Adding a Sub-System

<< Click to Display Table of Contents >>

Navigation:  AutoTRAX PCB Design Express (DEX) > Designs > Projects > Schematics > Hierarchical Design > Sub-Systems >

Adding a Sub-System

To add a sub-system to your design click the Add→Subclip0496 button.

You will be prompted for the name of the sub-system.


Enter its name and click the clip0498 button.

Move the mouse in the schematic viewport. As you mouse the mouse the point cursor shown below will appear. Left-click when the point cross is where you want the start corner of the sub-system or press the Enter key followed by the X value, Enter key, the Y value, and then Enter to precisely place the start corner of the sub-system.


As you move the mouse you will see the sub-system re-size.


Click the left mouse button when it is the correct size press the Enter key followed by the Width and Height coordinates of the sub-system shape.