Adding Coordinates

<< Click to Display Table of Contents >>

Navigation:  AutoTRAX PCB Design Express (DEX) > Designs > Drawing Aids > Coordinates >

Adding Coordinates

To add a coordinate to a sheet click on the clip0108 button in the AddDimension button group.

As you move the mouse cursor in the viewport, you will see the position cursor displayed below. You can press the 's' key to turn snap on/off.


Adding a Coordinate


When the coordinate is at the position you want to place it, left-click on to finish creating it.

You can enter the value of the X and Y coordinates by first pressing the Enter key followed by the X coordinate, the Enter key, the Y coordinate and finally the Enter key to complete creating the coordinate.


Entering the X and Y coordinate using the keyboard


Completed Coordinate