Editing Point Guides

<< Click to Display Table of Contents >>

Navigation:  AutoTRAX PCB Design Express (DEX) > Designs > Drawing Aids > Guides > Point Guides >

Editing Point Guides

There are 2 ways to edit a point guide, dragging it or using the Properties panel.


You can hold down the left mouse button on a guide and then drag the mouse to move the guide. You will see the X, Y values of the point change as you move it. Press the 's' key to turn snap on or off.


Point guide's vertical position displayed during dragging

Properties Panel

If you select a point guide and the Properties panel is visible, the point guide properties dialog will be shown.


Point guide properties


The X or horizontal position of the point guide.


The Y or vertical position of the point guide

Pressing the clip0114 button displays this help page.