Editing Rectangles

<< Click to Display Table of Contents >>

Navigation:  AutoTRAX PCB Design Express (DEX) > Designs > Graphics > Rectangles >

Editing Rectangles

To edit a rectangle first select it.


A selected rectangle

Drag either of the rectangle's corner manipulators( clip0265 ) to change the corners or ends.

Drag any rotate manipulator clip0266to rotate the rectangle.

Drag any scale manipulatorclip0319 to re-size the rectangle.

Drag the rectangle to move it.

Rectangle Properties Dialog

You can also edit the parameters of the rectangle using its properties panel as shown below. To view the properties panel first select it.Then right-click on it, then select Properties Panel from the context menu that opens.


Rectangle Properties Dialog


The X coordinate of the center of the rectangle.


The Y coordinate of the center of the rectangle


The width of the rectangle.


The height of the rectangle


Drag the slider to change the roundness of the rectangles corners.


Use this drop-down to set the layer for the rectangle.