Editing Terminal Magnets

<< Click to Display Table of Contents >>

Navigation:  Designing a PCB with AutoTRAX DEX > Designs > Parts > Symbols > Symbol Borders (Terminal Magnets) >

Editing Terminal Magnets

To edit a terminal magnet first select it. If the terminal magnet is on a schematic (project) then you will need to use sub-pick to select it.


A selected terminal magnet

Drag either of the border's corner manipulators(clip0319) to change the corners or ends.

Drag any scale manipulatorclip0319 to re-size the border.

Drag the border to move it.


Terminal Magnet Properties Dialog

You can also edit the parameters of the border using its properties panel as shown below. To view the properties panel first select it.Then right-click on it, then select Properties Panel from the context menu that opens.


Terminal Magnet Properties Dialog


The X coordinate of the center of the border.


The Y coordinate of the center of the border


The width of the border.


The height of the border

Reset Color

Click the clip0836 button to reset the fill color.