SAVE Lines

<< Click to Display Table of Contents >>

Navigation:  AutoTRAX PCB Design Express (DEX) > Designs > Circuit Simulation > The Spice Reference Manual > Analysis and output Control >

SAVE Lines

General form:

.SAVE vector vector vector ...


.SAVE i(vin) input output .SAVE @m1[id]

The vectors listed on the .SAVE line are recorded in the rawfile for use later with spice3 or nutmeg (nutmeg is just the data-analysis half of spice3, without the ability to simulate). The standard vector names are accepted. If no .SAVE line is given, then the default set of vectors are saved (node voltages and voltage source branch currents). If .SAVE lines are given, only those vectors specified are saved. For more discussion on internal device data, see Appendix B. See also the section on the interactive command interpretor for information on how to use the rawfile.